--------------------------------------------------------------------
In the moment the latest BMH.PRC is version 1.6, the lastest BMD.PRC
is version 1.7   (04/16/98).
--------------------------------------------------------------------

============================================
BATTERY MONITOR - Update procedure from v1.0
============================================

This section is only important, if you use the BM Hack v1.0.

Since I had to change the database structure since v1.0, all v1.0 users
would loose their so far collected battery data with the update. So I
implemented a little routine, that prevents that, if - AND ONLY IF -
you're following the update steps below:

1. Go to hackmaster and disable the BM Hack - DON'T delete it!
2. Install (hotsync) the new BMD - DON'T install the new BM Hack yet!
3. Now start Battery Monitor. The conversation is done now.
4. Install (hotsync) the new BM Hack - DON'T delete the old one!
5. Go to hackmaster and enable the BM Hack.
6. Done - you can use the new version as usual now.

As you can see, you DON'T have to delete any old version in the whole process.
That's ok and prevents, that the database goes also with the app or hack.

If you don't care about your previous data, you can of course also just delete
the old versions and hotsync both new programs at once.

!!! BUT (I get still awful lot e-mail about that matter): Whatever you do,
    a hack *HAS TO BE DISABLED* before you can delete it safely !!!
    That is not a matter of BM or any other hack, that's just a hackmaster rule.


======================================================
BATTERY MONITOR - Update procedure from v1.1 or higher
======================================================

All BM Hacks since v1.1 kept the data structure, so no complicated update
procedure, I only wanted to make sure, you don't loose any collected data:

DISABLE your old BM Hack (PLEASE!!), hotsync both new files (BMH and BMD),
and enable BM Hack again - that's it. The only important thing is, *NOT* to
delete your old BM Hack (deleting old BMD wouldn't harm the data, but is
unnecessary).


PLEASE NOTE FOR ALL UPDATES:
============================

Since each version could use additional or different settings than the previous
one, please be sure to visit at least once the settings screen and check whether
all settings are still ok.
BM reads your settings on start-up. If a feature wasn't there before, the
value it reads could be nonsense or wrong (however, buggy values are trapped).

(c)Peter Strobel - 1998, 16th April
